NOTE: THE G-CARD IS A READ-ONLY TYPE CARD. Now use the Value wheel to scroll through the presets and press the Enter key to load the new preset. Select the bank you want to recall, and move the cursor back to the “preset” parameter. Banks 1 & 2 contain 100 presets each and bank 3 contains the last 45 presets. You can now choose between the three banks of the G-Card by placing the cursor on the “bank” selector and dialing the Value wheel. When you want to load the presets, insert the G-Card and press the Recall key. HOW TO USE THE G-CARD The G-Card contains 245 presets partitioned into three banks. Note that the software version number during the start up sequence has now changed to 1.13. When the G-Force reads “Load PCMCIA” again, dial the Value wheel to “Start” and press Enter. After a brief pause, the G-Force will begin loading the new software. PRESS THE ENTER KEY TO LOAD THE NEW SOFTWARE. POWER ON IMMEDIATELY WHILE PRESSING AND HOLDING THE ENTER KEY. If the G-Force prompts “New Card”, you will need to update the G-Force software. If the G-Force card prompts “Card Accepted”, you have the right software and you can start using the card right away. This is what you do to check your software version and load the new software: - POWER OFF YOUR G-FORCE. 1 BEFORE YOU START USING THE G-CARD The G-Card requires that the G-Force has a current software version of 1.13 or later installed. WE HOPE THAT YOU HAVE AS MUCH PLEASURE USING IT AS WE HAD MAKING IT. CONGRATULATIONS CONGRATULATIONS ON THE PURCHASE OF YOUR NEW G-CARD.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |